Throttle Position Sensor

Turn ignition off and disconnect electrical connector at Throttle Position (TP) sensor. Insert a thickness gauge between throttle stop screw and throttle lever. Using an ohmmeter, check resistance values. See Fig 1. If values are not as specified in table, adjust or replace TP sensor.

Fig 1: Checking Throttle Position Sensor

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

THROTTLE POSITION SENSOR RESISTANCE SPECIFICATIONS

Throttle Clearance

Terminals

Ohmmeter Reading

0" (0 mm) ⁽¹⁾

VTA - E2

200-800

.020" (.50 mm) ⁽²⁾

IDL - E2

.035" (.90 mm) ⁽³⁾

IDL - E2

Infinity

Fully Open

VTA - E2

3300-10,000

Fully Open

VTA - E2 ⁽⁴⁾

3500-10,300

Fully Open

Vc - E2

3000-7000

Fully Open

Vc - E2 ⁽⁴⁾

4250-8250

⁽¹⁾	Reading must be 300-6300 ohms for Supra.

⁽²⁾	On Supra 7M-GE engine, use a feeler gauge thickness of .016" (.40 mm). Reading must be 2300 ohms or less for Supra.

⁽³⁾	On Supra 7M-GE engine, use a feeler gauge thickness of .030" (.75 mm).

⁽⁴⁾	Only applicable to Supra.