Carburetor (Tercel): Disassembly
- With carburetor off vehicle, remove air cleaner support bracket. Remove throttle position switch. Remove fuel cut solenoid valve and gasket. Remove fuel line union and gaskets.
- Install 4 mm bolt into suction chamber adjusting pin plug. Pry off plug with screwdrivers. See Fig 1. Remove "O" ring. Turn over carburetor and shake out pin. Remove 3 screws and pull suction chamber, spring and piston from carburetor body.
- Remove accelerator pump arm. Remove float bowl. Remove accelerator pump plunger and dust boots. Remove float and needle valve seat assembly. Remove throttle positioner. Remove vacuum tree adapter. Remove throttle position switch.
NOTE:
Compensator removal is not recommended unless replacement is required.