LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1991 >> Pickup Base, G57 >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor (3.0L) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Distributor (3.0L): Installation

  1. Install new "O" ring into distributor housing. Coat "O" ring with oil. Align protrusion on top of drive gear teeth with groove on distributor housing.
  2. Insert distributor with housing groove aligned with groove on No. 4 camshaft bearing cap. See Fig 1. Install distributor hold-down bolt, distributor cap and spark plug wires.
  3. Connect distributor wiring connector. Connect negative battery cable. Set ignition timing. Tighten distributor hold-down bolt. See TORQUE SPECIFICATIONS at end of article.
Fig 1: Installing Distributor (3.0L)
G119508Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals