LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1992 >> Tercel LE, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Fuel Pump >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

  1. Disconnect battery negative cable. Remove gas cap from filler tube to relieve fuel tank air pressure. Remove rear seat cushion. Disconnect fuel pump and fuel sender electrical connector. Remove fuel pump access cover. Release fuel pressure at filter. See FUEL SYSTEM PRESSURE RELEASE.
  2. Disconnect fuel lines from fuel pump bracket assembly. Remove bolts securing fuel pump and bracket assembly to fuel tank. Remove fuel pump and bracket assembly from tank.
  3. Remove nuts and washers retaining fuel sending unit wires. Disconnect wires. Remove screws retaining sending unit and separate sending unit from fuel pump and bracket assembly.
  4. Pull lower end of fuel pump (with filter) from bracket. Remove 2 nuts securing fuel pump wires to fuel pump. Disconnect wires. Disconnect fuel hose from fuel pump. Remove fuel pump.
  5. To install, reverse removal procedure. Use NEW retaining clip to install filter. Use NEW gasket between fuel pump bracket and tank. Tighten fuel pump bracket-to-tank nuts to 26 INCH lbs. (2.9 N.m). Turn ignition on and check for fuel leaks.
scientia non olet · About LEMON Manuals