LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1993 >> Celica ST, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ignition System: Distributor: Installation

  1. Set cylinder No. 1 to TDC of compression stroke. Coat new "O" ring with oil and install onto distributor housing. Align mark of drive coupling with groove on distributor housing. See Figure.
  2. Install distributor to camshaft, aligning distributor mounting flange hole slot with bolt hole on cylinder head. Snug distributor hold-down bolt/nut, but DO NOT  tighten. Connect distributor wiring connector. Install spark plug wires.
  3. To complete installation, reverse removal procedure. Connect negative battery cable. Start engine and set ignition timing. Tighten distributor hold-down bolt/nut(s). See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals