Section 12 (Engine Controls - System/Component Tests): Introduction: Notes

WARNING: This page is about a different car, the 1993 Toyota T100. However, it is still accessible from the selected car via links, so may be relevant.

Before testing separate components or systems, perform procedures in BASIC TESTING - V6 article. Since many computer-controlled and monitored components set a trouble code if they malfunction, also perform procedures in TESTS W/CODES article.

NOTE: Testing individual components does not isolate shorts or opens. Perform all voltage tests with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use ohmmeter to isolate wiring harness shorts or opens.

NOTE: When testing some systems, tachometer may be required. Tachometer must be connected to proper terminals. For tachometer connections, see IDLE SPEED & MIXTURE in ADJUSTMENTS - V6 article.