LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1993 >> Previa LE, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Cold Start Injector >> Removal & Installation (Previa 2.4L 2TZ-FE)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation (Previa 2.4L 2TZ-FE)

  1. Locate cold start injector at front of engine near EGR valve. Disconnect negative battery cable. Disconnect cold start injector connector. Slowly remove cold start injector pipe union bolt and 2 gaskets, using care not to spill fuel. Remove cold start injector and gasket.
  2. Install cold start injector with a NEW gasket. Tighten bolts to 48 INCH lbs. (5.4 N.m). Install injector pipe, union bolt and 2 NEW gaskets. Tighten union bolt to 14 ft. lbs. (19 N.m). Connect cold start injector connector and negative battery cable. Check for fuel leakage. See CHECKING FOR FUEL LEAKS.
scientia non olet · About LEMON Manuals