LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1994 >> Celica ST, 2D Hatchback, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ignition System: Distributor: Installation

  1. Coat NEW "O" ring with oil and install onto distributor housing. Remove right engine undercover and verify cylinder No. 1 is at TDC by viewing camshaft slot. Slot should be vertical with timing marks at TDC.
  2. Align cut-out portion of coupling with housing groove. See Figure. Insert distributor, aligning center of flange with bolt hole on cylinder head. Lightly tighten bolt. Connect spark plug wire to cap in proper order. Connect distributor electrical connector. Connect negative battery cable. Set ignition timing. Tighten distributor hold-down bolt/nut(s). See TORQUE SPECIFICATIONS TABLE at the end of this article.
scientia non olet · About LEMON Manuals