LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1994 >> MR2 2.2 S, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Cold Start Injector >> Removal & Installation (2.0L Turbo)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation (2.0L Turbo)

  1. Locate cold start injector under throttle body. Disconnect negative battery cable. Remove throttle body. See THROTTLE BODY. Disconnect cold start injector connector. Slowly remove cold start injector pipe union bolts (2) and gaskets 4. DO NOT spill fuel. Remove cold start injector and gasket.
  2. Install cold start injector with a NEW gasket. Tighten bolts to 52 INCH lbs. (5.9 N.m). Install injector pipe, 2 union bolts and 4 NEW gaskets. Tighten union bolt to 108 INCH lbs. (12 N.m). Connect cold start injector connector and throttle body. See THROTTLE BODY. Connect negative battery cable. Check for fuel leakage. See CHECKING FOR FUEL LEAKS.
scientia non olet · About LEMON Manuals