LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1994 >> Pickup Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Fuel Pump >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

  1. Disconnect negative battery cable. Release fuel pressure at filter. See FUEL SYSTEM PRESSURE RELEASE. Remove gas cap. Disconnect and plug fuel tank lines. Disconnect wiring harness connectors for fuel tank sending unit and fuel pump.
  2. Drain fuel, and remove fuel tank. Remove screws securing fuel pump bracket assembly to fuel tank, and remove fuel pump bracket assembly.
  3. Pull lower end of fuel pump (with filter) from bracket. Remove 2 nuts securing fuel pump wires to fuel pump, and disconnect wires. Disconnect fuel hose from fuel pump. Remove fuel pump. Using small blade screwdriver, remove clip retaining filter to pump.
  4. To install, reverse removal procedure. Use NEW retaining clip to install filter. Use NEW gasket between fuel pump bracket and tank. Tighten fuel pump bracket to specification. See TORQUE SPECIFICATIONS TABLE at the end of this article. Check for fuel leakage. See CHECKING FOR FUEL LEAKS.
scientia non olet · About LEMON Manuals