LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1994 >> Pickup Base >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Cold Start Injector >> Removal & Installation (3.0L)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation (3.0L)

  1. Locate cold start injector near EGR valve. Disconnect negative battery cable. Disconnect cold start injector connector. Slowly remove cold start injector pipe union bolt and 2 gaskets, using care not to spill fuel. Remove cold start injector and gasket.
  2. Install cold start injector with a NEW gasket. Apply Three-Bond Sealant (1324) or equivalent to 2 or 3 threads at bolt ends. Tighten bolts to 69 INCH lbs. (7.8 N.m). Install injector pipe, union bolt and 2 NEW gaskets. Tighten union bolt to 11 ft. lbs. (15 N.m). Connect cold start injector connector and negative battery cable. Check for fuel leakage. See CHECKING FOR FUEL LEAKS.
scientia non olet · About LEMON Manuals