Code Detection Test Drive (Calif.)
- Ensure ignition is off. Disconnect EFI fuse for 10 seconds or more. Connect jumper wire between DLC1 terminals TE2 and E1. Start engine and operate till at normal operate temperature.
- Idle engine for 3 minutes. Turn A/C on. Drive vehicle at 55-60 MPH on flat road for 4 minutes. Stop vehicle and turn off ignition for at least 3 seconds. Idle engine for 3 minutes. Drive vehicle at 55-60 MPH on flat road for 4 minutes. Stop vehicle. If malfunction exists, MIL will illuminate during test drive.