Specifications Index
PICKUP SPECIFICATIONS INDEX
| System | Specification/Procedure | |||
|---|---|---|---|---|
| Air Conditioning | ||||
| Service | REFRIGERANT OIL & REFRIGERANT SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Axle Shaft/Bearing Lock Nut/Drive Axle Nut (Front) | 61 ft. lbs. (83 N.m) | |||
| Battery | CAPACITIES - 2.4L CAPACITIES - 3.0L |
|||
| Brakes | ||||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | |||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | |||
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Charging | ||||
| Generator | ON-VEHICLE TESTING | |||
| Torque | OVERHAUL | |||
| Drive Belts | ||||
| Adjustment | BELT ADJUSTMENT | |||
| Belt Routing | BELT ROUTING | |||
| Engine Cooling | ||||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | |||
| Radiator Cap Pressure | 10.7-14.9 psi | |||
| Thermostat R & I | n/a | |||
| Water Pump R & I | ||||
| 2.4L | WATER PUMP | |||
| 3.0L | WATER PUMP | |||
| Engine Mechanical | ||||
| 2.4L | ||||
| Compression | ENGINE COMPRESSION | |||
| Oil Pressure | Oil pressure should be at least 4.3 psi (0.3 kg/cm2 ) at idle and 36-71 psi (2.5-5.0 kg/cm2 ) at 3000 RPM | |||
| Overhaul | ENGINE SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| 3.0L | ||||
| Compression | ENGINE COMPRESSION | |||
| Oil Pressure | Oil pressure should be at least 4.3 psi (0.3 kg/cm2 ) at idle and 36-75 psi (2.5-5.3 kg/cm2 ) at 3000 RPM | |||
| Overhaul | ENGINE SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | |||
| Flywheel/Flex Plate (Drive Plate) Torque | 61 ft.lbs (83 N.m) | |||
| Fuel System | ||||
| Pressure Specification | FUEL PRESSURE - 2.4L FUEL PRESSURE - 3.0L |
|||
| Fuel Pressure Test Procedure | FUEL PRESSURE - 2.4L FUEL PRESSURE - 3.0L |
|||
| Fuel Filter Location | ||||
| In Tank Type | FUEL SYSTEM - 2.4L FUEL SYSTEM - 3.0L |
|||
| Ignition | ||||
| 2.4L | ||||
| Firing Order & Cylinder Identification | FIRING ORDER | |||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | |||
| Ignition Wires (Routing) | IGNITION SYSTEM | |||
| 3.0L | ||||
| Firing Order & Cylinder Identification | FIRING ORDER | |||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | |||
| Ignition Wires (Routing) | IGNITION SYSTEM | |||
| Spark Plug | ||||
| 2.4L | ||||
| Type | NGK No. BKR5EY NIPPONDENSO No. W16EXR-U |
|||
| Gap | 0.031 In. (0.80 mm) | |||
| Torque | 13 ft.lbs (18 N.m) | |||
| 3.0L | ||||
| Type | NGK No. BKR5EYA NIPPONDENSO No. K16R-U |
|||
| Gap | 0.031 In. (0.80 mm) | |||
| Torque | 13 ft.lbs (18 N.m) | |||
| Starting | ||||
| Starter | STARTER SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Wheel Alignment | ||||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Wheel & Tire | ||||
| Wheel Lug Nut Torque | 83 ft.lbs (110 N.m) | |||