LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1995 >> Tercel Base, Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Testing >> Code P0136 - Heated Oxygen Sensor (Rear Sensor) Circuit >> Diagnosis & Repair
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair

  1. If any other codes are displayed other than Code P0136, diagnose and repair those codes first. If only Code P0136 is displayed, inspect circuits between ECM and sensor for opens or shorts. See wiring diagram in the WIRING DIAGRAMS article. Repair as needed.
  2. If all circuits are okay, connect scan tester. See Figure. Start and warm engine to normal operating temperature. Monitor oxygen sensor output voltage. Snap accelerate engine 3 times. Voltage should fluctuate from .4-.5 volt or more.
  3. If voltage responds correctly, inspect harness connection. Problem may be intermittent. If voltage does NOT respond correctly, replace sensor and retest.
scientia non olet · About LEMON Manuals