LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1996 >> Camry XLE, 2.2 G >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Tests W/Codes - 2.2L >> Self-Diagnostic System >> Retrieving Diagnostic Trouble Codes >> NORMAL Mode Code Retrieval
April 5, 2026: LEMON Manuals is launched! Read the announcement.

NORMAL Mode Code Retrieval

  1. Connect scan tester to DLC-3. Turn ignition on with engine off. Turn scan tester on. Using scan tester manufacturer's instructions, check for DTCs and freeze-frame data.
  2. If scan tester displays UNABLE TO CONNECT TO VEHICLE, DLC-3 must be checked. See DLC-3 INSPECTION  under SCAN TESTER PROBLEMS. If scan tester does not display UNABLE TO CONNECT TO VEHICLE, go to next step.
  3. Record any DTCs and freeze-frame data displayed for system diagnosis. If driveability problem exists and no DTCs are present, go to TESTS W/CODES - 2.2L article for diagnosis by symptom.
  4. If any DTCs are present, perform appropriate circuit test. See TROUBLE CODE IDENTIFICATION  table. For more information on freeze-frame data, see FREEZE-FRAME DATA  under INTRODUCTION. For information on 2-trip detection logic codes, see TWO-TRIP DETECTION LOGIC  under INTRODUCTION.
  5. After repairs for DTC have been completed, DTCs must be cleared from ECM memory. See CLEARING DIAGNOSTIC TROUBLE CODES .
scientia non olet · About LEMON Manuals