LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1996 >> Corolla Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System Tests W/Codes - 1.8L) >> Circuit Tests >> DTC P0325 - Knock Sensor Circuit >> Diagnosis & Repair
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair

WARNING: This page is about a different variant/trim than selected.
  1. Access ECM behind bottom center of instrument panel, in front of console. Disconnect ECM E9 connector. See Figure. Backprobing ECM connector, measure resistance between ground and terminal No. 13 (Black wire) at ECM E9 connector. If resistance is infinity, go to step 3). If resistance is not infinity, go to next step.
  2. Disconnect knock sensor connector. Check continuity between sensor terminal and sensor housing. If continuity does not exist, go next step. If continuity exists, replace sensor.
  3. Check for an open or short circuit in wiring harness between knock sensor and ECM. See appropriate wiring diagram in WIRING DIAGRAMS article. Repair as necessary. If circuit is okay, substitute knock sensor with known-good sensor. Clear and then retrieve codes. See SELF-DIAGNOSTIC SYSTEM . If code is still present, replace ECM. If code is no longer present, replace sensor.
scientia non olet · About LEMON Manuals