Section 4 (Engine Controls - Remove/Install/Overhaul - 1.8L): Introduction

WARNING: This page is about a different variant/trim than selected.

Removal, overhaul and installation procedures are covered in this article. If component removal and installation is primarily an unbolt and bolt-on procedure, only a torque specification may be furnished.

NOTE: References to California models applies to California emission vehicles, which may be verified by underhood Emission Control label. California emissions may be available in other states.

CAUTION: When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle.