Diagnosis & Repair
- Connect scan tester to DLC3 connector. See Figure. Start vehicle and warm engine to normal operating temperature. Turn on scan tester. Monitor sensor No. 1. Snap accelerate engine 3 times. Sensors should indicate a rich signal (.45 volt or more) at least once.
- If a rich signal is indicated at least once, replace ECM and retest. If sensor does not display a rich signal at least once, inspect circuits between ECM and suspect sensor for open or short circuits. See appropriate wiring diagram in WIRING DIAGRAMS article. Repair as necessary. If circuits are okay, replace heated oxygen sensor and retest.