LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1997 >> RAV4 2D Utility, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Tests W/Codes >> Circuit Tests >> DTC P0110: Intake Air Temperature (IAT) Sensor Circuit >> Diagnosis & Repair
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair

  1. Connect scan tool to DLC No. 3 connector. See Figure. Turn ignition on. Using scan tool, monitor IAT sensor temperature. If temperature displayed is same as outside temperature, check component and ECM connections. Problem is intermittent.
  2. If temperature displayed is 284°F (140°C) or more, go to step 5). If temperature displayed is -40°F (-40°C), turn ignition off. Disconnect IAT sensor connector. Connect a jumper wire between IAT sensor wiring harness connector terminals. Turn ignition on. Using scan tool, monitor IAT sensor temperature.
  3. If temperature displayed is 284°F (140°C) or more, replace IAT sensor and retest. If temperature displayed is less than 284°F (140°C), turn ignition off. Remove jumper wire. Access ECM behind bottom center of instrument panel, in front of console. Connect a jumper wire between terminals No. 3 (Yellow/Black wire) and No. 9 (Brown wire) at ECM E5 connector. See Figure.
  4. If temperature displayed on scan tool is 284°F (140°C) or more, check for an open in wiring harness between IAT sensor connector and ECM. See appropriate wiring diagram in WIRING DIAGRAMS article. Repair wiring as necessary. If temperature displayed on scan tool is less than 284°F (140°C), replace ECM and retest.
  5. Turn ignition off. Disconnect IAT sensor connector. Turn ignition on. If temperature displayed on scan tool is -40°F (-40°C), replace IAT sensor and retest. If temperature displayed is not -40°F (-40°C), turn ignition off.
  6. Access ECM behind bottom center of instrument panel, in front of console. Disconnect ECM E5 connector. See Figure. Turn ignition on. If temperature displayed is -40°F (-40°C), check and repair wiring harness between IAT sensor and ECM. See appropriate wiring diagram in WIRING DIAGRAMS article. If temperature displayed by scan tool is not -40°F (-40°C), replace ECM and retest.
scientia non olet · About LEMON Manuals