Circuit Description
The TP sensor is a variable resistor that monitors throttle opening. The ECM determines vehicle driving condition and adjusts air/fuel mixture accordingly. DTC is set when ECM consistently detects less than .1 volt on VTA circuit and closed throttle position switch is off. DTC will also be set if ECM consistently detects more than 4.9 volts on VTA circuit. DTC P0120 will not set if there is an open in IDL circuit. Possible causes are:
- Open or short in TP sensor circuit.
- TP sensor.
- ECM.
NOTE:
If DTCs P0110, P0115 and P0120 are output together, inspect ECM terminal E2 (ground) circuit. Repair as necessary. See appropriate wiring diagram in WIRING DIAGRAMS - 2.7L
article.