LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1999 >> RAV4 Base, 2D Utility, AWD, Automatic >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> MAZDA >> Programming Pcm (B2500, B3000, B4000 & 626) >> Flash Vehicle Identification (VID) Block Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Flash Vehicle Identification (VID) Block Procedure

  1. To perform this procedure NGS tester, Ford Service Function (FSF) card and NGS Flash Cable (007-00531) must be used. Plug flash cable into scan tool. Plug other end of flash cable into Data Link Connector (DLC). From the scan tool main menu, select SERVICE BAY FUNCTIONS, PCM-POWERTRAIN CONTROL MODULE and then PROGRAMMABLE MODULE INSTALLATION.
  2. The NGS tester display should show 2 selections. The first is selection is for the old PCM information to be retrieved and stored. The second selection is for restoring the new PCM with information that has been retrieved from the old PCM. Follow display instructions or refer to instruction sheet included with FSF card. If Vehicle Identification (VID) block has been reprogrammed previously, NGS tester will display a message indicating the need to reflash entire Integrated Circuit (IC). This procedure can only be performed using Ford's Service Bay Technical System (SBTS).
scientia non olet · About LEMON Manuals