Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION SENSOR

REMOVAL

1. REMOVE ENGINE UNDER COVER
2. REMOVE GENERATOR




3. REMOVE GENERATOR BRACKET
Remove the 3 bolts and bracket.

Torque:
- Bolt A: 74.5 Nm (760 kg.cm, 55 ft.lb)
- Bolt B: 18 Nm (180 kg.cm, 13 ft.lb)

4. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR




5. REMOVE CRANKSHAFT POSITION SENSOR
a. Remove the 2 bolts and crankshaft position sensor.

Torque: 8.5 Nm (85 kg.cm, 74 in.lb)

b. Remove the O-ring.

HINT:
- At the time of assembly please refer to the following items.
- Apply a light coat of engine oil on the O-ring. Install the crankshaft position sensor with a new O-ring.

INSTALLATION
Installation is in the reverse order of removal.