HTR Sub1 Relay: Echo
- Remove HTR SUB1 relay from fuse/relay box located at driver-side front corner of engine compartment, just in front of strut tower, near battery. See Fig 1.
- Note terminals on HTR SUB1 relay. See Fig 1. To test HTR SUB1 relay continuity, using ohmmeter, check that continuity exists between terminals No. 1 and 2 on HTR SUB1 relay, and that no continuity exists between terminals No. 3 and 5 on HTR SUB1 relay. If continuity and no continuity are as specified, go to next step. If continuity and no continuity are not as specified, replace HTR SUB1 relay.
- To test HTR SUB1 relay operation, apply battery voltage and ground to terminals No. 1 and 2 on HTR SUB1 relay. Using ohmmeter, check that continuity exists between terminals No. 3 and 5 on HTR SUB1 relay. Replace HTR SUB1 relay if continuity does not exist between terminals No. 3 and 5.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002