LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2000 >> RAV4 Base, AWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Control System Self-Diagnostics) >> Diagnostic Tests >> DTC P1120: Accelerator Pedal Position (App) Sensor Circuit >> Diagnosis & Repair (Using Toyota Hand-Held Tester)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair (Using Toyota Hand-Held Tester)

WARNING: This page is about a different car, the 2000 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect Toyota hand-held tester to Data Link Connector (DLC) No. 3. See Figure. Turn ignition on. Using hand-held tester, monitor APP sensor voltage for VPA and VPA2 circuits. See ACCELERATOR PEDAL POSITION SENSOR VOLTAGE  table. If voltage is as specified, replace ECM. If voltage is not as specified, go to next step.
    ACCELERATOR PEDAL POSITION SENSOR VOLTAGE

    Accelerator Pedal Volts
    Depressed
    VPA Circuit 3.2-4.8
    VPA2 Circuit 4.7-5.1
    Released
    VPA Circuit 0.3-0.9
    VPA2 Circuit 1.8-2.7
  2. Access ECM behind glove box. Turn ignition on. Using DVOM, backprobe ECM harness connector and measure voltage between terminals No. 2 (Blue/Red wire) and No. 18 (Brown/White wire) at ECM harness connector E6. See Figure. If voltage is 4.5-5.5 volts, go to next step. If voltage is not 4.5-5.5 volts, replace ECM.
  3. Using DVOM, backprobe ECM harness connector and measure voltage between terminals No. 18 (Brown/White wire) and No. 21 (Red wire) at ECM harness connector E6. With fully closed throttle, voltage should be .3-.9 volt. With fully open throttle, voltage should be 3.2-4.8 volts. Using DVOM, backprobe ECM harness connector and measure voltage between terminals No. 18 (Brown/White wire) and No. 9 (Red/Black wire) at ECM harness connector E6. With fully closed throttle, voltage should be 1.8-2.7 volts. With fully open throttle, voltage should be 4.7-5.1 volts. If voltage readings are as specified, replace ECM. If voltage readings are not as specified, go to next step.
  4. Check APP sensor. See THROTTLE BODY under IDLE CONTROL SYSTEMS in SYSTEM & COMPONENT TESTING - V6 & V8 article. If problem exists, replace APP sensor. If problem does not exist, repair open or short in wiring between ECM and APP sensor. See WIRING DIAGRAMS article.
scientia non olet · About LEMON Manuals