DTC P0441: Incorrect EVAP Purge Flow, Or DTC P0446: EVAP Vent Control Circuit: Notes

WARNING: This page is about a different car, the 2000 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If ECM replacement is instructed in following testing, always ensure ECM connectors and ground circuit are okay. If either are suspect, repair and repeat testing to confirm ECM malfunction. If ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see appropriate ENGINE IMMOBILIZER SYSTEMS article in ACCESSORIES & EQUIPMENT.

NOTE: If DTC P0441, P0446, P0450 or P0451 is output after DTC P0440, perform appropriate test first before performing DTC P0440 test.

NOTE: For component location, see appropriate illustration in THEORY & OPERATION article.