LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2000 >> RAV4 Base, AWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Engine Control System Self-Diagnostics) >> Diagnostic Tests >> DTC P0500: Vehicle Speed Sensor Circuit >> Diagnosis & Repair
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair

WARNING: This page is about a different car, the 2000 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. Test drive vehicle and check operation of speedometer. If speedometer is not operating correctly, repair speedometer as necessary. See appropriate INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT. If speedometer is operating correctly, go to next step.
  2. Access ECM behind glove box. Ensure ignition is off. Disconnect ECM harness connector E9. Check continuity between ground and terminal No. 22 (Violet/Yellow wire) at ECM harness connector E9. See Figure. If continuity exists, locate and repair short to ground. If continuity does not exist, go to next step.
  3. Turn ignition on. Measure voltage between ground and terminal No. 22 (Violet/Yellow wire) at ECM harness connector E12. If voltage is 9-14 volts, replace ECM. If voltage is not 9-14 volts, repair open in wiring between instrument cluster and ECM. See WIRING DIAGRAMS article.
scientia non olet · About LEMON Manuals