LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2000 >> RAV4 L, AWD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Self-Diagnostics >> Diagnostic Tests >> DTC P1520: Stoplight Switch Signal Circuit (A/T Only) >> Diagnosis & Repair
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair

  1. Check stoplight operation. If stoplights do not operate properly, repair as necessary and retest system. See EXTERIOR LIGHTS article in ACCESSORIES & EQUIPMENT. If stoplights operate properly, go to next step.
  2. Access ECM behind bottom center of instrument panel, in front of console. Turn ignition on. Using DVOM, backprobe ECM harness connector and measure voltage between ground and terminal No. 4 (Green/White wire) at ECM harness connector E6. See Figure. With brake pedal depressed, voltage should be 7.5-14.0 volts. With brake pedal released, voltage should be less than 1.5 volts. If voltage is not as specified, go to next step. If voltage is as specified, problem is intermittent. Check wiring and connectors.
  3. Check for short in wiring between ECM and stoplight switch. If problem exists, repair wiring as necessary. If problem does not exist, replace ECM.
scientia non olet · About LEMON Manuals