Specifications Index
SIENNA SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Shaft/Axle Hub Nut Torque | |||
| Axle Shaft Hub Nut (Front) | 217 ft.lbs (294 N.m) | ||
| Axle Hub to Axle Beam Nuts (Rear) | 59 ft.lbs (80 N.m) | ||
| Battery | NA | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | ON-VEHICLE TESTING | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | DRIVE BELT ADJUSTMENTS | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 12.1-16.4 psi (.85-1.15 kg/cm2
) (Minimum opening pressure is 10.0 psi.) |
||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | At normal operating temperature, oil pressure should be at least 4.3 psi (0.3 kg/cm2 ) at idle and 43-78 psi (3.0-5.5 kg/cm2 ) at 3000 RPM. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab | ||
| Flywheel/Flex Plate (Drive Plate) Torque | |||
| Drive Plate Bolt (A/T) | 61 Ft.lbs. (83 N.m) | ||
| Flywheel Bolts (M/T) | 61 Ft.lbs. (83 N.m) | ||
| Fuel System | |||
| Pressure Specification | 44-50 psi (3.1-3.5 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | SIENNA | ||
| Fuel Filter Location | |||
| FUEL FILTER ON FUEL PUMP | |||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | Refer to illustrations in FIRING ORDER | ||
| Spark Plug | |||
| Type | NGK No. BKR6EKPB11 DENSO No. PK20TR11 |
||
| Gap | .043 In. (1.10 mm) | ||
| Torque | 13 Ft. Lbs. (18 N.m) | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 76 Ft.lbs. (103 N.m) | ||