Inspection Procedure

CHECK: 

Check the continuity of the POWER and JCB M-fuses, and MPX-B and ECU-IG fuse.

OK: Continuity 

1. NG: Replace failure fuse. 
2. OK: Go to next step. 

PREPARATION: 

Turn the ignition switch ON.

CHECK: 

Measure the voltage between terminals IG and GND.

OK: Voltage: 10-14 V 

PREPARATION: 

1. Turn the ignition switch OFF.
2. Disconnect the back door ECU connector. CHECK:

Measure the voltage between terminals POWE/ECU-B and GND.

OK: Voltage: 10-14 V 

1. OK: Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ). 
2. NG: Go to next step. 

1. NG: Repair or replace harness or connector. 
2. OK: Check and repair harness and connector between back door ECU and battery.