Test Drive Confirmation
- Test drive confirmation may be performed to operate vehicle under conditions which may cause DTC to be set. If using Toyota hand-held tester, go to next step. If Toyota hand-held tester is not available, go to step 3.
- Connect hand-held tester to Data Link Connector (DLC) No. 3. See Figure. Switch hand-held tester from NORMAL mode to CHECK mode.
- Start engine. Allow engine to idle for at least 60 seconds.
- Drive vehicle at 24 MPH or more for at least 40 seconds and then allow engine to idle for at least 10 seconds. Repeat this procedure 9 times and then check operation of Malfunction Indicator Light (MIL). If MIL illuminates, malfunction exists and DTC is set. If MIL does not illuminate, malfunction does not exist.