DTC P0441: Incorrect EVAP Purge Flow, Or DTC P0446: EVAP Vent Control Malfunction: Notes

CAUTION: If Engine Control Module (ECM) replacement is instructed in following test, always ensure ECM electrical connectors and ground circuits are okay. If either are defective, repair and repeat testing to confirm ECM malfunction. On models equipped with engine immobilizer, if ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION, or appropriate ENGINE IMMOBILIZER SYSTEMS article in ACCESSORIES & EQUIPMENT.

NOTE: If DTC P0441, P0446, P0450 or P0451 is output after DTC P0440, perform appropriate test for these DTCs first before performing test for DTC P0440.