Specifications Index
4RUNNER SPECIFICATIONS INDEX
| System | Click To Access | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | |||
| Automatic | SPECIFICATIONS | ||
| Manual | SPECIFICATIONS | ||
| Torque | |||
| Automatic | TORQUE SPECIFICATIONS | ||
| Manual | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| 2WD | NA | ||
| 4WD | 174 ft.lbs (235 N.m) | ||
| Battery | NA | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc & Drum Brakes | DISC & DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | ON-VEHICLE INSPECTION | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | NA | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | Standard opening pressure: 74-103 kPa (0.75-1.05 kgf/cm2
, 10.7 - 14.9 psi) Minimum opening pressure: 59 kPa (0.6 kgf/cm2 , 8.5 psi) |
||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | Oil pressure should be at least 4.3 psi (0.3 kg/cm2
) at idle and 36-75 psi (2.5-5.2 kg/cm2
) at 3000 RPM. (At normal operating temperature) |
||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab | ||
| Flywheel/Flex Plate (Drive Plate) Torque | 61 Ft.lbs. (83 N.m) | ||
| Fuel System | |||
| Pressure Specification | 38-44 psi (2.7-3.1 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | TACOMA, TUNDRA 3.4L V6 & 4RUNNER | ||
| Fuel Filter Location | FUEL FILTER | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | Refer to illustration in FIRING ORDER & TIMING MARKS | ||
| Spark Plug | |||
| Type | NGK No. BKR5EKB-11 DENSO No. K16TR11 |
||
| Gap | .043 In. (1.10 mm) | ||
| Torque | 13 Ft. Lbs. (18 N.m) | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | SPECIFICATIONS | ||
| Torque | Refer to applicable components under WHEEL ALIGNMENT PROCEDURES | ||
| Wheel & Tire | |||
| Lug Nut Torque | 81 ft.lbs. (110 N.m) | ||