Specifications Index
LAND CRUISER SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Axle Shaft/Axle Drive Shaft/ Hub Nut | NA | |
| Battery | NA | |
| Brakes | ||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | |
| Disc Brakes | DISC BRAKE SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Charging | ||
| Generator | ON-VEHICLE INSPECTION | |
| Torque | TORQUE SPECIFICATIONS | |
| Drive Belts | ||
| Adjustment | BELT ADJUSTMENT | |
| Belt Routing | DRIVE BELT ROUTING | |
| Engine Cooling | ||
| Service | COOLING SYSTEM SPECIFICATIONS | |
| Radiator Cap Pressure | 13.5-17.8 psi (Minimum opening pressure is 11.4 psi.) |
|
| Thermostat R & I | THERMOSTAT | |
| Water Pump R & I | WATER PUMP | |
| Engine Mechanical | ||
| Compression | ENGINE COMPRESSION | |
| Oil Pressure | At normal operating temperature, oil pressure should be at least 4.3 psi (0.3 kg/cm2 ) or more at idle and approximately 43-85 psi (3.0-5.9 kg/cm2 ) or more at 3000 RPM. | |
| Overhaul | ENGINE SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab | |
| Flywheel/Flex Plate (Drive Plate) Torque | ||
| Flywheel/Drive Plate Bolt | Step 1) 36 Ft.lbs. (49 N.m) Step 2) Additional 90 Degree Turn |
|
| Fuel System | ||
| Pressure Specification | 38-44 psi (2.7-3.1 kg/cm2 ) | |
| Fuel Pressure Test Procedure | LAND CRUISER & SEQUOIA | |
| Fuel Filter Location | ||
| FUEL FILTER | ||
| Ignition | ||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | |
| Ignition Wires (Routing) | NA | |
| Spark Plug | ||
| Type | NGK No. IFR6A11 DENSO No. SK20R11 |
|
| Gap | .043 In. (1.10 mm) | |
| Torque | 13 Ft. Lbs. (18 N.m) | |
| Starting | ||
| Starter | STARTER SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel Alignment | ||
| Adjustment Specifications | SPECIFICATIONS | |
| Torque | Refer to applicable components in PROCEDURES | |
| Wheel & Tire | ||
| Wheel Lug Nut Torque | 97 Ft.lbs. (131 N.m) | |