Specifications Index
PRIUS SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Shaft/Bearing Lock Nut/Drive Axle Nut | |||
| Front | |||
| Drive Shaft Lock Nut | 159 Ft.lbs (216 N.m) | ||
| Rear | |||
| Axle Hub-to-Axle Beam Bolts | 38 Ft.lbs (52 N.m) | ||
| Battery | NA | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | DISC & DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | NA | ||
| Torque | NA | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 10.7-14.9 psi (.75-1.05 kg/cm2
) Minimum opening pressure is 8.5 psi (.59 kg/cm2 )FUEL PUMP |
||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | |||
| At Idle Speed | 4.3 psi (0.3 kg/cm2 ) or more | ||
| At 3000 RPM | 22-80 psi (1.5-5.6 kg/cm2 ) | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Flywheel/Flex Plate (Drive Plate) Torque | |||
| Flywheel-to-Crankshaft | 62 Ft.lbs (84 N.m) | ||
| Fuel System | |||
| Pressure Specification | 44-50 psi (3.1-3.5 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | PRIUS | ||
| Fuel Filter Location | |||
| FUEL FILTER | |||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | NA | ||
| Spark Plug | |||
| Type | NGK No. IFR5A11 DENSO No. SK16R11 |
||
| Gap | .043 In. (1.10 mm) | ||
| Torque | 13 Ft.lbs (18 N.m) | ||
| Starting | |||
| Starter | NA | ||
| Torque | NA | ||
| Wheel Alignment | |||
| Adjustment Specifications | SPECIFICATIONS | ||
| Torque | Refer to applicable components in procedures: FRONT WHEEL ALIGNMENT REAR WHEEL ALIGNMENT |
||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 76 Ft.lbs (103 N.m) | ||