Inspection Procedure

Check Power Gauge Door Dome Fuse And Power Relay.
CHECK:

Check continuity of POWER GAUGE DOOR DOME Fuse and POWER Relay.

OK:

Continuity
1. NG: Replace the failure fuse.
2. OK: Go to next step.
OK: Check Voltage Between Terminals P/W IG B And E Of Body ECU Connector.
PREPARATION:

Turn ignition switch ON.

CHECK:

Measure voltage between terminals IG and E.

OK:

Voltage: 10 - 14V

PREPARATION:
1. Turn ignition switch OFF.
2. Disconnect the Body ECU connector.
  CHECK:
  
  Measure voltage between terminals P/W B and E.
  
  OK:
  
  Voltage: 10 - 14V
1. OK: Proceed to next circuit inspection shown on problem symptoms table. See PROBLEM SYMPTOMS TABLES .
2. NG: Go to next step.
Check Wire Harness And Connector Between Body ECU And Body Ground. See HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE .
1. NG: Repair or replace wire harness or connector.
2. OK: Check and repair wire harness and connector between Body ECU and battery. See HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE .