Specifications Index
TUNDRA SPECIFICATIONS INDEX
| System | Specification/Procedure | |||
|---|---|---|---|---|
| Air Conditioning | ||||
| Service | SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Axle Shaft Nut/Lock Nut | ||||
| Front (4WD) | 173 Ft. lbs. (235 N.m) | |||
| Rear | NA | |||
| Battery | NA | |||
| Brakes | ||||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | |||
| Disc Brakes | DISC & DRUM BRAKE SPECIFICATIONS | |||
| Drum Brakes | DISC & DRUM BRAKE SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Charging | ||||
| Generator | ||||
| 3.4L (2UZ-FE) | ON-VEHICLE INSPECTION | |||
| 4.7L (5VZ-FE) | ON-VEHICLE INSPECTION | |||
| Torque | ||||
| 3.4L (2UZ-FE) | TORQUE SPECIFICATIONS | |||
| 4.7L (5VZ-FE) | TORQUE SPECIFICATIONS | |||
| Drive Belts | ||||
| Adjustment | BELT ADJUSTMENT | |||
| Belt Routing | ||||
| 3.4L (2UZ-FE) | NA | |||
| 4.7L (5VZ-FE) | DRIVE BELT ROUTING | |||
| Engine Cooling | ||||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | |||
| Radiator Cap Pressure | ||||
| 3.4L (2UZ-FE) | 10.7-14.9 psi (Minimum opening pressure is 8.5 psi.) |
|||
| 4.7L (5VZ-FE) | 10.7-14.9 psi (Minimum opening pressure is 8.8 psi.) |
|||
| Thermostat R & I | ||||
| 3.4L (2UZ-FE) | THERMOSTAT | |||
| 4.7L (5VZ-FE) | THERMOSTAT | |||
| Water Pump R & I | ||||
| 3.4L (2UZ-FE) | WATER PUMP | |||
| 4.7L (5VZ-FE) | WATER PUMP | |||
| Engine Mechanical | ||||
| Compression | ENGINE COMPRESSION | |||
| Oil Pressure | ||||
| 3.4L (2UZ-FE) | At normal operating temperature, oil pressure should be at least 4.3 psi (0.3 kg/cm2 ) or more at idle and 36-75 psi (2.5-5.2 kg/cm2 ) at 3000 RPM. | |||
| 4.7L (5VZ-FE) | At normal operating temperature, oil pressure should be at least 4.3 psi (0.3 kg/cm2 ) or more at idle and approximately 43-85 psi (3.0-5.9 kg/cm2 ) at 3000 RPM. | |||
| Overhaul | ||||
| 3.4L (2UZ-FE) | ENGINE SPECIFICATIONS | |||
| 4.7L (5VZ-FE) | ENGINE SPECIFICATIONS | |||
| Torque | ||||
| 3.4L (2UZ-FE) | TORQUE SPECIFICATIONS | |||
| 4.7L (5VZ-FE) | TORQUE SPECIFICATIONS | |||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab | |||
| Flywheel/Flex Plate (Drive Plate) Torque | ||||
| 3.4L (2UZ-FE) | TORQUE SPECIFICATIONS | |||
| 4.7L (5VZ-FE) | TORQUE SPECIFICATIONS | |||
| Fuel System | ||||
| Pressure Specification | ||||
| 3.4L & 4.7L | 38-44 psi (2.7-3.1 kg/cm2 ) | |||
| Fuel Pressure Test Procedure | ||||
| 3.4L (2UZ-FE) | TACOMA, TUNDRA 3.4L V6 & 4RUNNER | |||
| 4.7L (5VZ-FE) | TUNDRA 4.7L V8 | |||
| Fuel Filter Location | ||||
| V6 & V8 | FUEL FILTER | |||
| Ignition | ||||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | |||
| Ignition Wires (Routing) | Refer to illustration in FIRING ORDER & TIMING MARKS | |||
| Spark Plug | ||||
| Type Gap Torque |
SPARK PLUGS | |||
| Starting | ||||
| Starter | STARTER SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Wheel Alignment | ||||
| Adjustment Specifications | SPECIFICATIONS | |||
| Torque | Refer to applicable components in PROCEDURES | |||
| Wheel & Tire | ||||
| Wheel Lug Nut Torque | 81 Ft.lbs. (110 N.m) | |||