Service Data
SFI SERVICE SPECIFICATIONS
| Component/Condition | Specifications | |
|---|---|---|
| Fuel Pressure Regulator | ||
| Fuel Pressure | 301-347 kPa (3.1-3.5 kgf/cm2 , 44-50 psi) | |
| Fuel Pump | ||
| Resistance At 20°C (68°F) | 0.2-3.0 ohm | |
| Injector | ||
| Resistance At 20°C (68°F) | 13.4-14.2 ohm | |
| Injection Volume | 47-58 cm3 (2.7-3.3 cu in.) per 15 seconds | |
| Difference Between Each Cylinder | 10 cm3 (0.6 cu in.) or less | |
| Fuel Leakage | One drop or less per 12 minutes | |
| Mass Air Flow Meter | ||
| Resistance At -20°C (-4°F) | 13.6-18.4 kohm | |
| At 20°C (68°F) | 2.21-2.69 kohm | |
| At 60°C (140°F) | 0.49-0.67 kohm | |
| Throttle Position Sensor (1ZZ-FE Engine) | ||
| Clearance between stop screw and lever 0 mm (0 in.): VTA-E2 | 0.2-5.7 kohm | |
| Throttle Valve Fully Open: VTA-E2 | 2.0-10.2 kohm | |
| VC-E2 | 2.5-5.9 kohm | |
| Throttle Control Motor (2ZZ-GE Engine) | ||
| Resistance At 20°C (68°F) | 0.3-100 kohm | |
| Camshaft Timing Oil Control Valve | ||
| Resistance At 20°C (68°F) | 6.9-7.9 ohm | |
| VSV (CCV) | ||
| Resistance At 20°C (68°F) | 24-30 ohm | |
| VSV (pressure Switching Valve) | ||
| Resistance At 20°C (68°F) | 37-44 ohm | |
| At 120°C (248°F) | 51 -62 ohm | |
| VSV (EVAP) | ||
| Resistance At 20°C (68°F) | 27-33 ohm | |
| VSV (Intake Air Control Valve) | ||
| Resistance At 20°C (68°F) | 37-44 ohm | |
| ECT Sensor | ||
| Resistance At -20°C (-4°F) | 10-20 kohm | |
| At 0°C (32°F) | 4-7 kohm | |
| At 20°C (68°F) | 2-3 kohm | |
| At 40°C (104°F) | 0.9-1.3 kohm | |
| At 60°C (140°F) | 0.4-0.7 kohm | |
| At 80°C (176°F) | 0.2-0.4 kohm | |
| Vapor Pressure Sensor | ||
| Power Source Voltage | 4.5-5.5 V | |
| Remove Fuel Tank Cap: Terminal 2-3 | 3.0-3.6 V | |
| Knock Sensor (2ZZ-GE Engine) | ||
| Resistance At 20°C (68°F) | 120-280 ohm | |
| Heated Oxygen Sensor | ||
| Heater Coil Resistance | 11-16 ohm | |
| Fuel Cut RPM | ||
| Fuel Return RPM | 1,500 rpm | |