LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2003 >> Matrix Base, FWD, Automatic >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 64 (Engine Control System Self-Diagnostics) >> Diagnostic Tests >> DTC P0500: Vehicle Speed Sensor Circuit >> Diagnosis & Repair
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair

WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Test drive vehicle and check operation of speedometer. If speedometer operates properly, go to next step. If speedometer does not operate properly, repair speedometer as necessary. See appropriate INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT. Speedometer may not operate, as input signal from ABS ECU may not be input to instrument cluster.
  2. Remove glove box for access to ECM with electrical connectors still installed on ECM. See Figure. Disconnect ECM electrical connector E7. See Figure. Using ohmmeter, check for continuity between body ground and terminal No. 22 (Violet/White wire) at ECM electrical connector E7. See Figure. This is the SPD terminal on ECM. If no continuity exists, go to next step. If continuity exists, repair short to ground in Violet/White wire and electrical connectors between ECM and instrument cluster. See WIRING DIAGRAMS article.
  3. Ensure electrical connector E7 is still disconnected at ECM. Turn ignition on. Using voltmeter, check voltage between body ground and terminal No. 22 (Violet/White wire) at ECM electrical connector E7. See Figure. This is the SPD terminal on ECM. Voltage should be 9-14 volts. If voltage is within specification, replace ECM. If voltage is not within specification, repair open in Violet/White wire and electrical connectors between ECM and instrument cluster. See WIRING DIAGRAMS article.
scientia non olet · About LEMON Manuals