Confirmation Driving Pattern
WARNING: This page is about a different car, the 2003 Lexus GX 470. However, it is still accessible from the selected car via links, so may be relevant.
- Connect hand-held tester to DLC3. See Figure. If you do not have a hand-held tester, perform steps 2-5, turn ignition switch off, and perform steps 2-5 again.
- Switch hand-held tester from normal mode to check mode.
- Start engine and let engine idle for 60 seconds or more.
- Drive vehicle at 25 MPH or more for 40 seconds or more.
- Let engine idle for 10 seconds or more.
- Perform steps 3 and 4 12 times. If there is a malfunction, MIL will illuminate during step 5. If the conditions in test are not strictly followed, detection of malfunction will not be possible.