Section 212 (Charging System - Generators & Regulators): Overhaul: Generator: Assembly
WARNING: This page is about a different car, the 2004 Toyota Corolla and 2003 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
Use generator Pulley Set Nut Wrench Set (SST 09820-63010) to install generator pulley. Place SST "C" securely into a vise. Install SST "A" and "B" and generator into SST "C". See Figure. Tighten pulley nut in the opposite direction of disassembly. See TORQUE SPECIFICATIONS . Using 29mm socket, slowly press in rectifier end frame. To complete assembly procedure, reverse disassembly procedure. After completing assembly, verify rotor turns smoothly.