LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2003 >> Matrix Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Body Control Systems) >> System Tests >> Test No. 34: Power Door Lock System Does Not Operate At All
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test No. 34: Power Door Lock System Does Not Operate At All

WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check DOOR No. 1 fuse (25-amp), DOOR No. 2 fuse (15-amp) and GAUGE No. 1 fuse (10-amp). DOOR No. 1 and GAUGE No. 1 fuses are located in driver side junction block under left side of instrument panel. See Figure. DOOR No. 2 fuse is located in engine compartment junction block at left side of engine compartment, in front of shock tower. See Figure. If fuses are okay, go to next step. If any fuse is defective, repair short in wiring for appropriate fuse and replace fuse. See POWER DOOR LOCKS and POWER DISTRIBUTION in SYSTEM WIRING DIAGRAMS article.
  2. Check driver door control system. See DRIVER DOOR CONTROL SYSTEM  under TROUBLE SHOOTING. After repairs, perform confirmation test. See CONFIRMATION TEST . If driver door control system is okay, go to next step.
  3. Check body control ECU ground circuits. See BODY COMPUTER in SYSTEM WIRING DIAGRAMS article. If ground circuits are faulty, repair and retest system. If ground circuits are okay, substitute original body control ECU with a known-good unit and recheck system operation. If system operates properly, original body control ECU was defective. If system still does not operate properly, perform body control ECU pin voltage check. See BODY CONTROL ELECTRONIC CONTROL UNIT  under PIN VOLTAGE TESTS. Check wiring harness and electrical connectors for an intermittent problem. Repair wiring harnesses or connectors as necessary. If voltage values, harnesses and connectors are okay, replace body control ECU. After repairs, perform confirmation test. See CONFIRMATION TEST . If symptom is still present, go to next step.
  4. Check wiring harness and electrical connectors between battery and body control ECU, between battery and driver side junction block, between battery and engine compartment junction block, between driver side junction block and driver door ECU, front passenger door ECU and body control ECU, between engine compartment junction block and body control ECU, between body control ECU and rear passenger door power door lock motors, between driver door ECU and driver door power door lock motor, between front passenger door ECU and front passenger door power door lock motor, and all power and ground connections. See POWER DOOR LOCKS in SYSTEM WIRING DIAGRAMS article. If wiring harnesses or electrical connectors are defective, repair as necessary. After repairs, perform confirmation test. See CONFIRMATION TEST .
scientia non olet · About LEMON Manuals