DTC P0450: EVAP Pressure Sensor Circuit Or DTC P0451: EVAP Pressure Sensor Range/Performance: Notes

WARNING: This page is about a different car, the 2002 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If Engine Control Module (ECM) replacement is instructed in following test, always ensure ECM electrical connectors and ground circuits are okay. If either are defective, repair and repeat testing to confirm ECM malfunction.

NOTE: If DTCs P0110, P0115, P0120, P0450 and P1120 are output simultaneously, the E2 sensor ground circuit at terminal No. 18 (Green/White wire) at ECM electrical connector E6 may be open. See WIRING DIAGRAMS article. For ECM electrical connector terminal identification, see Figure. It may be necessary to check Green/White wire between splice I7 and terminal No. 18 at ECM electrical connector E6. Splice I7 is located behind passenger's side of instrument panel. See Figure.

NOTE: If DTC P0441, P0446, P0450 or P0451 is output after DTC P0440, perform appropriate test for these DTCs first before performing test for DTC P0440.