Inspection Procedure

WARNING: This page is about a different car, the 2004 Lexus ES 330. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FUSE
1. Check the PWR NO. 3 fuse.
NG: REPLACE FUSE

OK: Go to next step.
CHECK POWER WINDOW REGULATOR SWITCH ASSY REAR (POWER SOURCE)

Fig 1: Checking Power Window Regulator Switch Assy Rear (Power Source)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disconnect the R16 power window regulator switch assy rear (RH side) connector.
2. Check the voltage between terminal BDR (R16-12) connector of regulator switch and the body ground.
Standard: 10 - 14 V

NG: REPAIR OR REPLACE WIRE HARNESS AND CONNECTOR

OK: Go to next step.
CHECK POWER WINDOW REGULATOR SWITCH ASSY REAR (GROUND)

Fig 2: Checking Power Window Regulator Switch Assy Rear (Ground)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disconnect the R16 power window regulator switch assy rear (RH side) connector.
2. Check the continuity between terminal GND (R16-7) connector of regulator switch and the body ground.
Standard: Continuity

NG: REPAIR OR REPLACE WIRE HARNESS AND CONNECTOR

OK: Go to FLOW CHART (POWER WINDOW REGULATOR MOTOR CIRCUIT) (See POWER WINDOW REGULATOR SWITCH CIRCUIT (REAR RH DOOR) )