Section 249 (Charging System - Generators & Regulators - 5VZ-FE): Generator: Replacement

WARNING: This page is about a different car, the 2002 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

Replace Front Bearing
1. Remove the 4 screws and bearing retainer.
  
  Fig 1: Locating Bearing Retainer Screws For Removal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST and a press, press out the bearing.
  SST 09950-60010 (09951-00260, 09952-06010)
  
  Fig 2: Using SST Press Out Bearing
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST and a press, press in a new bearing.
  SST 09950-60010 (09951-00520)
4. Install the bearing retainer with the 4 screws.
  1. Torque:
  2. 3.0 N.m (31 kgf.cm, 27 in.lbf)
Fig 3: Using SST Press In New Bearing
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Replace Rear Bearing
1. Using SST, remove the bearing cover (outside) and bearing.
  SST 09820-00021
  
  NOTE: Be careful not to damage the fan.
2. Remove the bearing cover (inside).
  
  Fig 4: Removing Rear Cover (Outside) & Bearing
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Place the bearing cover (inside) on the rotor.
  
  Fig 5: Placing Bearing Cover (Inside) On Rotor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using SST and a press, press in a new bearing.
  SST 09820-00031
  
  Fig 6: Using SST Press In New Bearing
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Using SST, push in the bearing cover (outside). SST 09285-76010
Fig 7: Push In Bearing Cover (Outside)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002