LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2003 >> RAV4 Base, AWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Air Bag Restraint Systems) >> Diagnostic Tests >> DTC B1163/82: Short To Battery In Right Side Head Impact Air Bag Module Squib Circuit >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

WARNING: This page is about a different car, the 2003 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Access air bag sensor assembly and disconnect right harness connector. See AIR BAG SENSOR ASSEMBLY  under REMOVAL & INSTALLATION. Access right side head impact air bag module and disconnect harness connector. See HEAD IMPACT AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect negative battery cable. Turn ignition switch to ON position. Measure voltage in Yellow/Violet wire between ground and harness side of right side head impact air bag squib harness connector. See WIRING DIAGRAMS . If voltage is less than one volt, go to next step. If voltage is more than one volt, repair or replace harness or connector between right side head impact air bag module and air bag sensor assembly.
  2. Turn ignition switch to LOCK position. Disconnect negative battery cable. Wait at least 90 seconds. Reconnect air bag sensor assembly right harness connector. Connect jumper wire between Yellow/Orange and Yellow/Violet wire on harness side of right side head impact air bag squib harness connector. Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING DTCS  under DIAGNOSTICS. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Retrieve DTCs. See RETRIEVING DTCS  under DIAGNOSTICS. If DTC 82/B1163 is not displayed, go to next step. If DTC 82/B1163 is displayed, replace air bag sensor assembly.
  3. Turn ignition switch to LOCK position. Disconnect negative battery cable. Wait at least 90 seconds. Reconnect right side head impact air bag squib harness connector. Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING DTCS  under DIAGNOSTICS. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Retrieve DTCs. See RETRIEVING DTCS  under DIAGNOSTICS. If DTC 82/B1163 is not displayed, go to next step. If DTC 82/B1163 is displayed, replace right side head impact air bag module.
  4. Check for intermittent air bag system fault. See AIR BAG WARNING LIGHT INTERMITTENT . If AIR BAG warning light illuminates while checking for intermittent fault, go to step  1. If AIR BAG warning light does not illuminate while checking for intermittent fault, replace all air bag system components, including wiring harness.
scientia non olet · About LEMON Manuals