LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2003 >> RAV4 Base, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Air Bag Restraint Systems) >> Diagnostic Tests >> DTC B0102/11: Driver-Side Air Bag Module Squib Circuit Short To Ground >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

WARNING: This page is about a different car, the 2003 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Access air bag sensor assembly and disconnect center harness connector. See AIR BAG SENSOR ASSEMBLY  under REMOVAL & INSTALLATION. Remove driver-side air bag module. See DUAL-STAGE DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Measure resistance in Yellow/Black wire (circuit D+) between ground and harness side of upper spiral cable connector. See WIRING DIAGRAMS . If resistance is more than one megohm, go to next step. If resistance is less than one megohm, go to step  5.
  2. Reconnect air bag sensor assembly center connector. Connect jumper wire between Yellow/Black wire and Yellow wire (circuit D-) on harness side of upper spiral cable connector. Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING DTCS  under DIAGNOSTICS. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Retrieve DTCs. See RETRIEVING DTCS  under DIAGNOSTICS. If DTC 11/B0102 is displayed, replace air bag sensor assembly. If DTC 11/B0102 is not displayed, go to next step.
  3. Turn ignition switch to LOCK position. Disconnect negative battery cable. Wait at least 90 seconds. Connect driver-side air bag harness connector to upper spiral cable connector. Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Clear DTCs. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Retrieve DTCs. If DTC 11/B0102 is displayed, replace driver-side air bag module. If DTC 11/B0102 is not displayed, go to next step.
  4. Check for intermittent air bag system fault. See AIR BAG WARNING LIGHT INTERMITTENT . If AIR BAG warning light illuminates while checking for intermittent fault, go to step  1. If AIR BAG warning light does not illuminate while checking for intermittent fault, replace all air bag system components, including wiring harness.
  5. Disconnect lower spiral cable harness connector. Measure resistance in Yellow/Black wire between ground and harness side of lower spiral cable connector. If resistance is more than one megohm, go to next step. If resistance is less than one megohm, replace wiring harness between air bag sensor assembly and spiral cable.
  6. Measure resistance in Yellow/Black wire between ground and harness side of upper spiral cable connector. If resistance is more than one megohm, go to next step. If resistance is less than one megohm, replace spiral cable. See SPIRAL CABLE  under REMOVAL & INSTALLATION.
  7. Check for intermittent air bag system fault. See AIR BAG WARNING LIGHT INTERMITTENT . If AIR BAG warning light illuminates while checking for intermittent fault, go to step  1. If AIR BAG warning light does not illuminate while checking for intermittent fault, replace all air bag system components, including wiring harness.
scientia non olet · About LEMON Manuals