Torque Specifications
Manual Transaxle Torque Specifications
| Part tightened | N.m | kgf.cm | ft.lbf | |
|---|---|---|---|---|
| Filler and drain plugs | 39 | 400 | 29 | |
| Hood x Body | 13 | 133 | 9.6 | |
| Lower suspension arm x Lower ball joint | 128 | 1,310 | 94 | |
| Starter x Transaxle | 37 | 378 | 28 | |
| Clutch release cylinder x Transaxle | 12 | 120 | 9 | |
| Clutch release cylinder x Release cylinder heat insulator | 12 | 120 | 9 | |
| Clutch line set bolt | Bolt A | 25 | 255 | 18 |
| Bolt B | 12 | 120 | 9 | |
| Bolt C | 5 | 51 | 44 in..lbf | |
| Pressure feed tube set bolt | 51.5 | 525 | 38 | |
| Discharge tube set bolt | 9.8 | 100 | 87 in..lbf | |
| Liquid tube set bolt | 9.8 | 100 | 87 in..lbf | |
| No. 2 engine hangers set bolt | 38 | 387 | 28 | |
| Right engine mounting insulator | Bolt and 2 nuts | 52 | 530 | 38 |
| Left engine mounting insulator | Through bolt and nut | 56 | 571 | 41 |
| Front exhaust pipe | Exhaust manifold side | 43 | 439 | 32 |
| Center pipe side | 49 | 500 | 36 | |
| Stabilizer bar link x Stabilizer bar | 44 | 450 | 32 | |
| Front suspension crossmember assembly x PS gear assembly | 137 | 1,397 | 101 | |
| Front suspension crossmember assembly x Body | 113 | 1,150 | 82 | |
| Lower suspension arm bracket x Body | 157 | 1,600 | 115 | |
| Engine rear mounting insulator through bolt | 88 | 898 | 65 | |
| Engine front mounting insulator through bolt | 56 | 571 | 41 | |
| Center member x Body | 39 | 400 | 28 | |
| RH front drive shaft set bolt | 64 | 650 | 47 | |
| Axle hub x Drive shaft | 216 | 2,200 | 150 | |
| Center support bearing x Body (4WD) | 37 | 375 | 27 | |
| Propeller shaft assembly x Rear differential (4WD) | 74 | 750 | 54 | |
| Transaxle with engine x Transfer stiffener plate (4WD) | 34 | 347 | 25 | |
| Transmission case protector x Transaxle (4WD) | 18 | 180 | 13 | |
| Transaxle x Engine | Bolt A | 64 | 650 | 47 |
| Bolt B | 46 | 470 | 34 | |
| Bolt C | 44 | 440 | 32 | |
| Transaxle x Transfer assembly (4WD) | 2 bolt and 5 nuts (17 mm) | 78.4 | 800 | 58 |
| nut (14 mm) | 29.4 | 300 | 22 | |
| Back - up light switch | 40 | 410 | 30 | |
| Vehicle speed sensor installation bolt | 17 | 175 | 13 | |
| Control cable bracket x Transaxle case | 17 | 175 | 13 | |
| Clutch tube bracket x Transaxle case | 17 | 175 | 13 | |
| Selecting bellcrank assembly set bolt | 20 | 200 | 14 | |
| Control shift lever set nut | 6.4 | 65 | 57 in..lbf | |
| Lock ball assembly | 29 | 300 | 22 | |
| Shift and select lever shaft assembly x Transmission case | 20 | 200 | 14 | |
| Transmission case cover x Transmission case | 29 | 300 | 22 | |
| Breather plug | 49 | 500 | 36 | |
| Output shaft lock nut | 123 | 1,250 | 90 | |
| Shift fork and shift head set bolt | 24 | 240 | 17 | |
| Rear bearing retainer x Transmission case | 42 | 430 | 31 | |
| Straight screw plug | 25 | 250 | 18 | |
| Reverse idler gear shaft lock bolt | 29 | 300 | 22 | |
| Transmission case x Transaxle case | Transaxle case side | 29 | 300 | 21 |
| Transmission case side | 30 | 306 | 22 | |
| Reverse shift arm bracket assembly x Transaxle case | 17 | 175 | 13 | |
| No. 1 and No. 2 oil receiver pipes x Transmission case | 17 | 175 | 13 | |
| Transaxle case receiver x Transaxle case | 7.0 | 71 | 62 in..lbf | |
| Straight screw plug (Reverse restrict pin) | 13 | 130 | 9 | |
| Transmission oil pump case x Oil pump cover | 10 | 105 | 8 | |
| Differential case x Ring gear | (4WD) | 124 | 1,260 | 91 |
| (2WD) | 106 | 1,080 | 78 | |
| Shift lever assembly x Body | 12 | 120 | 9 | |
| Shift cable grommet retainer x Body | 5.0 | 51 | 44 in..lbf | |
| Transfer | ||||
| Drain and filler plug | 49 | 500 | 36 | |
| Drive pinion lock nut | 349 | 3,560 | 257 | |
| Use with SST | 308 | 3,142 | 227 | |
| Center differential control coupling x Ring gear | 77.5 | 791 | 57 | |
| Bearing retainer RH x Transfer case | 28 | 286 | 21 | |
| Extension housing x Transfer case | 25.5 | 260 | 19 | |
| Stud bolt x Transfer case | 39.2 | 400 | 29 | |
| Oil deflector x Case cover No.1 | 6.5 | 66 | 58 in..lbf | |
| Case cover No.1 x Transfer case | 19.6 | 200 | 14 | |