October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Input Shaft (MAINSHAFT): Inspection
- Inspect all parts for damage and wear. Replace if necessary. Clean all parts in solvent, dry and lubricate all parts. Ensure oil passages are free of contamination.
- Measure input shaft at points "A", "B" and "C". See Figure. Support input shaft on "V" blocks. Using a dial indicator, rotate input shaft 2 complete revolutions and measure shaft runout. See Figure. Replace input shaft if runout is not within service limit. See INPUT SHAFT BEARING SPECIFICATIONS table.
INPUT SHAFT BEARING SPECIFICATIONS
| Application |
Minimum Diameter - In. (mm) |
| "A" Journal Diameter |
1.1004 (27.950) |
| "B" Journal Diameter |
1.415 (35.95) |
| "C" Journal Diameter |
1.415 (35.95) |
| Runout Limit |
.002 (.05) |