Starter Specifications
STARTER SPECIFICATIONS
| Application | In. (mm) | ||
|---|---|---|---|
| Brush | |||
| Length | |||
| Standard | .551 (14) | ||
| Minimum | .354 (9) | ||
| Holder Female (Replacement) | |||
| Thickness | .130 (3.3) | ||
| Width | .276 (7) | ||
| Holder Male (Field Coil Side) | |||
| Weld Mark Thickness | .063 (1.6) | ||
| Width | .197 (5) | ||
| Center Bearing | |||
| Inside Diameter | .5908-.5925 (15.08-15.05) | ||
| Standard Shaft Diameter | .5898-.5906 (14.98-15) | ||
| Oil Clearance | |||
| Maximum | .0078 (.2) | ||
| Standard | .0004-.0024 (.01-.06) | ||
| Commutator | |||
| Diameter | |||
| Minimum | 1.063 (27) | ||
| Standard | 1.102 (28) | ||
| Runout | .0020 (.05) | ||
| Undercut Depth | |||
| Standard | .024 (.6) | ||
| Minimum | .008 (.2) | ||
| Pinion Gear Standard Clearance | .04-.2 (1-5) | ||
| Spring Load | |||
| Installed Minimum | 2 Lb. (.9 Kg.) | ||
| Installed Standard | 3.1-4 Lb. (1.4-1.8 Kg.) | ||