Wheel Alignment Specifications & Adjustment Procedures: Specifications

Use illustration for wheel alignment specifications. See G00212731REAR .

G00212731REAR

Cold tire inflation pressure

Tire size

P275/70R16

Front

200 kPa (2.0 kgf/cm² , 29 psi)

⁽¹⁾220 kPa (2.2 kgf/cm² , 32 psi)

Rear

220 kPa (2.2 kgf/cm² , 32 psi)

⁽¹⁾240 kPa (2.4 kgf/cm² , 35 psi)

Front wheel alignment

Vehicle height

Front

A - B

71 mm (2.795 in.)

Rear

C - D

51 mm (2.008 in.)

Camber

0°05' ± 45' (0.08° ± 0.75°)

Right-left error

30' (0.5°) or less

Caster

2°30' ± 45' (2.5° ± 0.75°)

Right-lefterror

30' (0.5°) or less

Steering axis inclination

12°10' ± 45' (12.17° ± 0.75°)

Right-left error

30' (0.5°) or less

Toe-in (total)

0°06' ± 12' (0.1° ± 0.2°, 1 ± 2 mm, 0.04 ± 0.08 in.)

Rack end length difference

3.0 mm (0.118 in.) or less

Wheel angle

Inside wheel

36°42' (33°42' - 36°42')
36.7° (33.7°-36.7°)

Outside wheel: Reference

32° 36'
32.6°

Front axle

Front axle hub preload (at starting)

42 - 67 N (4.3 - 6.8 kgf, 9.5 - 15.0 lbf)

Snap ring thickness

1.8 mm (0.0709 in.)
2.0 mm (0.0787 in.)
2.2 mm (0.0866 in.)
2.4 mm (0.0945 in.)
2.6 mm (0.1024 in.)
2.8 mm (0.1102 in.)

Front drive shaft

Front drive shaft length

573.9 ± 5.0 mm (22.594 ± 0.197 in.)

Front suspension

Upper suspension arm ball joint turning torque

1.0 - 4.4 N.m (10 - 45 kgf.cm, 8.9 - 39 in..lbf)

Lower suspension arm ball joint turning torque

0.29 - 2.94 N.m (3 - 30 kgf.cm, 2.6 - 26 in..lbf)

Rear axle shaft

Bearing backlash

Max.

0.6 mm (0.024 in.)

Axle shaft deviation

Max.

0.05 mm (0.0020 in.)

Axle shaft runout

Max.

2.0 mm (0.079 in.)

Axle shaft flange runout

Max.

0.05 mm (0.0020 in.)

⁽¹⁾	Trailer towing

A: Ground clearance of spindle center
B: Ground clearance of lower suspension arm front bolt center
C: Ground clearance of rear axle shaft center
D: Ground clearance of lower control arm front bushing center